Ford 2006 Mustang v.1 Manuel d'utilisateur télécharger pdf (Page 39)

2. Remove the sight shield by

loosening the six fasteners with a

flat head screwdriver.

3. Remove the two underhood bolts

attaching the bumper cover next to

the grill and then pull the

cover/grille/foglamp assembly

forward to access the foglamp bulbs.

4. Disconnect the electrical

connector from the bulb by pulling

it straight off.

5. Rotate the bulb counterclockwise and remove from the lamp assembly.

Install the new bulb in reverse order.

Replacing tail lamp/brake/rear turn signal lamp bulbs

The tail lamp, the brake lamp and the turn signal lamp bulbs are located

in the tail lamp assembly. Follow the same steps to replace either bulb.

1. Make sure headlamp switch is in

OFF position, then open the trunk.

2. Carefully remove fasteners

around the lamp area and then

remove the interior trunk trim.

3. Disconnect the electrical grommet

by pulling it straight off of the lamp

assembly.

4. Remove three nut and washer

assemblies and the lamp assembly

from the vehicle.

5. Remove the bulb socket by rotating it counterclockwise, then pulling it

out of the lamp assembly.

6. Pull the bulb straight from the

socket.

Install the new bulb in reverse

order.

2006 05+ Mustang (197)

Owners Guide (post-2002-fmt)

USA (fus)

Lights

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 247 248

Pas de commentaire

Ford 2006 Mustang v.1 Manuel d'utilisateur Page 39