Ford 2006 Mustang v.1 Manuel d'utilisateur télécharger pdf (Page 40)

Replacing backup bulbs

The backup lamp is located in the tail lamp assembly. Follow the same

steps to replace either bulb.

1. Make sure headlamp switch is in

OFF position, then open the trunk.

2. Carefully remove fasteners

around the lamp area, then remove

the interior trunk trim.

3. Disconnect the electrical

connector by pulling it straight off

of the lamp assembly.

4. Remove the three nut and washer

assemblies and the lamp assembly

from the vehicle.

5. Remove the bulb socket by rotating it counterclockwise, then pulling it

out of the lamp assembly.

6. Pull the bulb straight from the

socket.

Install the new bulb in reverse

order.

Replacing rear sidemarker lamp bulbs

1. Make sure the headlamp switch is

in the OFF position and locate the

sidemarker on the rear bumper

fascia.

2. Install a flathead screwdriver

between the rear of the sidemarker

lens and the bumper fascia.

3. Push the screwdriver to the front

of the vehicle and then slide it towards you to pop out the lens cover.

4. Carefully pull the bulb straight out of socket.

Install the new bulb in reverse order.

2006 05+ Mustang (197)

Owners Guide (post-2002-fmt)

USA (fus)

Lights

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 247 248

Pas de commentaire

Ford 2006 Mustang v.1 Manuel d'utilisateur Page 40