Ford 2003 Expedition v.2 Manuel d'utilisateur télécharger pdf (Page 148)

Smart unlocking feature

The smart unlocking feature prevents you from locking yourself out of

the vehicle by unlocking the doors if the key is in the ignition and the

driver’s door is open/ajar when the vehicle doors were locked using the

power lock/unlock control.

The smart unlocking feature operates independent of the position of the

ignition.

Autolocking feature

The autolocking feature locks all vehicle doors when the following

conditions are met:

• All doors, including the liftgate, are closed.

• The brake is pressed while the ignition is in the RUN position.

• The transmission is in either a forward or reverse gear.

• The vehicle has a speed of 8 km/h (5 mph) or greater.

This feature relocks all doors if any door is opened, the brake is pressed

after all doors are closed again and the vehicle has a speed of 8 km/h

(5 mph) or greater.

Deactivating/activating the autolock feature

For vehicles equipped with a message center, the autolock feature may

be deactivated/activated by selecting the autolock function (accessed by

pressing the SETUP control). Press the RESET control to turn the

autolock function ON or OFF. Refer to Message center in the Driver

controls chapter for additional information.

For vehicles not equipped with a message center, perform the following

steps in order to deactivate/activate the autolock feature:

Before following the procedure, make sure that the ignition is in the OFF

position.

You must complete steps 1-7 within 30 seconds or the procedure will

have to be repeated. If the procedure needs to be repeated, you must

wait 30 seconds.

1. Turn the ignition key to ON.

2. Press the power door unlock control three times.

3. Turn the ignition key from ON to OFF.

4. Press the power door unlock control three times.

5. Turn the ignition back to ON. The horn will chirp.

Locks and Security

148

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 343 344

Pas de commentaire

Ford 2003 Expedition v.2 Manuel d'utilisateur Page 148