Ford 2003 Expedition v.2 Manuel d'utilisateur télécharger pdf (Page 222)

• additional engine downhill braking is desired. If towing a trailer, refer

to Driving while you tow in the Trailer towing section.

To return to

(Overdrive) mode, press the transmission control switch

(TCS). The TCIL will no longer be illuminated.

Each time the vehicle is started, the transmission will automatically

return to normal overdrive mode.

Every time the vehicle is shut off and restarted, you must press the

transmission control switch to cancel overdrive operation if driving in

overdrive is not desired.

2 (Second)

Use 2 (Second) to start-up on

slippery roads or to provide

additional engine braking on

downgrades.

1 (First)

Use 1 (Low) to provide maximum

engine braking on steep

downgrades. Upshifts can be made

by shifting to 2 (Second) or to

(Overdrive). Selecting 1 (Low) at

higher speeds causes the transmission to shift to a lower gear, and will

shift to 1 (Low) after vehicle decelerates to the proper speed.

Forced Downshifts

To gain acceleration in

(Overdrive) or Drive (O/D OFF) when

passing another vehicle, push the accelerator to the floor. The

transmission will downshift to the appropriate gear: third, second or first

gear.

If your vehicle gets stuck in mud or snow

If your vehicle gets stuck in mud or snow, it may be rocked out by

shifting from forward and reverse gears, stopping between shifts in a

steady pattern. Press lightly on the accelerator in each gear.

Do not rock the vehicle if the engine is not at normal operating

temperature or damage to the transmission may occur.

Do not rock the vehicle for more than a minute or damage to the

transmission and tires may occur, or the engine may overheat.

If your vehicle is equipped with AdvanceTrac娂, it may be beneficial to

turn the system off so the wheels are allowed to spin.

Driving

222

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 343 344

Pas de commentaire

Ford 2003 Expedition v.2 Manuel d'utilisateur Page 222