Ford 2003 Expedition v.2 Manuel d'utilisateur télécharger pdf (Page 102)

5. Rotate the bulb socket

counterclockwise and remove from

the lamp assembly.

6. Carefully pull the bulb out of the

socket and push in the new bulb.

7. Install the bulb socket into the

lamp assembly and rotate clockwise.

8. Replace the lamp assembly and

install all three retainer bolts on the

lamp assembly.

Replacing tail/stop/turn/sidemarker/backup lamp bulbs

The tail/stop/turn/sidemarker/backup

lamp bulbs are located in the same

portion of the tail lamp assembly,

one just below the other. Follow the

same steps to replace either bulb:

1. Make sure the headlamp switch is

in the OFF position and then open

the liftgate to expose the lamp

assembly screws.

2. Remove the two screws from the

lamp assembly.

3. Carefully remove the lamp assembly away from the vehicle by pulling

the assembly straight out to expose the bulb socket. DO NOT TIP THE

LAMP ASSEMBLY SIDEWAYS.

4. Rotate the bulb socket counterclockwise and remove from lamp

assembly.

5. Pull bulb straight out of socket and snap in the new bulb.

6. Install the bulb socket into the lamp assembly and rotate clockwise.

7. Carefully install the tail lamp assembly on the vehicle by securing the

lamp assembly with two screws.

Replacing foglamp bulbs

Handle a halogen headlamp bulb carefully and keep out of

children’s reach. Grasp the bulb only by its plastic base and do

not touch the glass. The oil from your hand could cause the bulb to

break the next time the headlamps are operated.

Lights

102

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 343 344

Pas de commentaire

Ford 2003 Expedition v.2 Manuel d'utilisateur Page 102