Ford 2003 Expedition v.2 Manuel d'utilisateur télécharger pdf (Page 129)

Compass zone/calibration adjustment

1. Determine your magnetic zone by

referring to the zone map.

2. Turn ignition to the ON position.

3. Start the engine.

4. From Info menu, select the

Compass/Odometer function. (Do

not select Trip, DTE, or AFE. The

top of the message center must be

blank).

5. Press and hold the SETUP and

RESET controls until the message

center display changes to show the

current zone setting (XX).

6. Press the SETUP control

repeatedly until the correct zone setting for your geographic location is

displayed on the message center. The range of zone values are from 01

to 15 and “wraps” back to 01.

7. To exit the zone setting mode,

and to “lock in” your change, press

and release the RESET control.

Perform compass calibration in an open area free from steel structures

and high voltage lines. For optimum calibration, turn off all electrical

accessories (heater/air conditioning, wipers, etc.) and make sure all

vehicle doors are shut.

8. Press the RESET control to start

the compass calibration function.

9. Slowly drive the vehicle in a

circle (less than 5 km/h [3 mph])

until the CIRCLE SLOWLY TO

CALIBRATE display changes to CALIBRATION COMPLETED. It will take

up to five circles to complete calibration.

123

6 7 8 9 1011

Driver Controls

129

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 343 344

Pas de commentaire

Ford 2003 Expedition v.2 Manuel d'utilisateur Page 129