Ford 2005 E-450 v.3 Manuel d'utilisateur télécharger pdf (Page 75)

After any vehicle collision, the safety belt systems at all outboard

seating positions (except the driver position, which does not

have this feature) must be checked by a qualified technician to verify

that the automatic locking retractor feature for child seats is still

functioning properly. In addition, all seat belts should be checked for

proper function.

BELT AND RETRACTOR ASSEMBLY MUST BE REPLACED if

the seat belt assembly “automatic locking retractor” feature or

any other seat belt function is not operating properly when checked

according to the procedures in Workshop Manual. Failure to replace

the Belt and Retractor assembly could increase the risk of injury in

collisions.

Safety belt pretensioner

Your vehicle is equipped with safety belt pretensioners at the driver and

front outboard passenger seating positions.

The safety belt pretensioner is a device which removes excess webbing

from the safety belt system. The safety belt pretensioner uses the same

crash sensor system as the front airbag supplemental restraint system

(SRS). When the safety belt pretensioner deploys, webbing from the lap

and shoulder belt is tightened. Refer to the Safety belt maintenance

section in this chapter.

The driver and front passenger seat belt system (including

retractors, buckles and height adjusters) must be replaced if the

vehicle is involved in a collision that results in deployment of front

airbags and safety belt pretensioners.

2005 Econoline (eco)

Owners Guide (post-2002-fmt)

USA (fus)

Seating and Safety Restraints

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 247 248

Pas de commentaire

Ford 2005 E-450 v.3 Manuel d'utilisateur Page 75