Ford 2005 E-450 v.3 Manuel d'utilisateur télécharger pdf (Page 115)

Front axle jacking points:

Place the jack under the pin on the

front surface of the front axle.

Do not place the jack under or

on the steering linkage.

• Raise the jack until the wheel is

completely off the ground. (Turn

jack handle clockwise if your

vehicle is equipped with a

screw-type jack or pump the jack

if equipped with a hydraulic

jack.)

• Remove the lug nuts with the lug

nut wrench.

• Replace the flat tire with the

spare tire.

If your vehicle has single rear wheels, thread the lug nuts on the studs

with the beveled face toward the wheel.

If your vehicle has dual rear wheels, thread the two element swiveling

lug nuts on the studs with the flange facing toward the wheel.

3. Use the lug nut wrench to screw the lug nut snugly against the wheel.

4. Lower the vehicle by turning the jack handle counterclockwise.

5. Remove the jack and fully tighten the lug nuts in the following pattern

(Refer to Wheel lug nut torque specifications later in this chapter for

the proper lug nut torque specification):

• 5-lug wheel

2005 Econoline (eco)

Owners Guide (post-2002-fmt)

USA (fus)

Tires, Wheels and Loading

115

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 247 248

Pas de commentaire

Ford 2005 E-450 v.3 Manuel d'utilisateur Page 115