Ford 2002 Mustang v.1 Manuel d'utilisateur télécharger pdf (Page 117)

The BeltMinder feature can be deactivated/activated

by performing the following procedure:

Before following the procedure, make sure that:

• The parking brake is set.

• The gearshift is in P (Park) (automatic

transmission) or the neutral position (manual

transmission).

• The ignition switch is in the OFF position.

• All vehicle doors are closed.

• The driver’s safety belt is unbuckled.

• The parklamps/headlamps are in OFF position (If

vehicle is equipped with Autolamps, this will not

affect the procedure).

To reduce the risk of injury, do not

deactivate/activate the Belt Minder feature

while driving the vehicle.

1. Turn the ignition switch to the RUN (or ON)

position. (DO NOT START THE ENGINE.)

2. Wait until the safety belt warning light turns off.

(Approximately 1–2 minutes.)

• Steps 3–5 must be completed within 60 seconds

or the procedure will have to be repeated.

3. Buckle then unbuckle the safety belt three times,

ending with the safety belt unbuckled. This can be

done before or during BeltMinder warning activation.

4. Turn on the parklamps/headlamps, turn off the

parklamps/headlamps.

5. Buckle then unbuckle the safety belt three times,

ending with the safety belt unbuckled.

• After step 5 the safety belt warning light will be

turned on for three seconds.

6. Within seven seconds of the safety belt warning

light turning off, buckle then unbuckle the safety

belt.

Seating and Safety Restraints

117

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 263 264

Pas de commentaire

Ford 2002 Mustang v.1 Manuel d'utilisateur Page 117