Ford 2002 F-150 v.2 Manuel d'utilisateur télécharger pdf (Page 115)

If two previously programmed coded keys are not available, you must

bring your vehicle to your dealership to have the spare coded key(s)

programmed.

Please read and understand the entire procedure before you begin.

1. Insert the first previously

programmed coded key into the

ignition and turn the ignition from 1

(OFF) to 3 (ON) (maintain ignition

in 3 (ON) for at least one second,

but no more than ten seconds).

2. Turn ignition to 1 (OFF) then 2

(ACC) and remove the first coded

key from the ignition.

3. Within ten seconds of removing

the first coded key, insert the second previously programmed coded

key into the ignition and turn the ignition from 1 (OFF) to 3 (ON)

(maintain ignition in 3 (ON) for at least one second but no more than

ten seconds).

4. Turn the ignition to 1 (OFF) then 2 (ACC) and remove the second

coded key from the ignition.

5. Within 10 seconds of removing the second coded key, insert the new

unprogrammed key (new key/valet key) into the ignition and turn the

ignition from 1 (OFF) to 3 (ON) (maintain ignition in 3 (ON) for at least

one second, but no more than ten seconds). This step will program your

new key to a coded key.

6. To program additional new unprogrammed key(s), repeat this

procedure from step 1.

If successful, the new coded key(s) will start the vehicle’s engine and the

theft indicator will illuminate for three seconds and then go out.

If not successful, the new coded key(s) will not start the vehicle’s engine

and the theft indicator will flash on and off and you may repeat steps 1

through 5. If failure repeats, bring your vehicle to your dealership to

have the new spare key(s) programmed.

Locks and Security

115

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 311 312

Pas de commentaire

Ford 2002 F-150 v.2 Manuel d'utilisateur Page 115