Ford 2002 Explorer Sport Trac v.2 Manuel d'utilisateur télécharger pdf (Page 51)

3. Press the SET ACC control and

release it.

4. Take your foot off the accelerator

pedal.

5. The indicator light

SPEED

CONT

on the

instrument cluster will turn on.

Note:

• Vehicle speed may vary momentarily when driving up and down a

steep hill.

• If the vehicle speed increase above the set speed on a downhill, you

may want to apply the brakes to reduce the speed.

• If the vehicle speed decreases more than 16 km/h (10 mph) below

your set speed on an uphill, your speed control will disengage.

Resuming a set speed

Press the RSM (resume) control and

release it. This will automatically

return the vehicle to the previously

set speed. The RSM control will not

work if the vehicle speed is not

faster than 48 km/h (30 mph).

Increasing speed while using speed control

There are two ways to set a higher

speed:

• Press and hold the SET ACC

control until you get to the

desired speed, and then release

the control. You can also use the

SET ACC control to operate the

Tap-Up function. Press and

release this control to increase the vehicle set speed in small amounts

by 1.6 km/h (1 mph).

• Use the accelerator pedal to get to the desired speed. When the

vehicle reaches that speed press and release the SET ACC control.

Driver Controls

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 199 200

Pas de commentaire

Ford 2002 Explorer Sport Trac v.2 Manuel d'utilisateur Page 51