Ford 2002 Explorer Sport Trac v.2 Manuel d'utilisateur télécharger pdf (Page 174)

To check and add fluid:

1. Drive the vehicle 30 km (20 miles) to reach normal operating

temperatures.

2. If driven in hot weather, city traffic, pulling a trailer, allow

transmission to cool for 30 minutes before checking.

3. Engage parking brake, start engine.

4. Put your foot on the brake pedal and move the gearshift lever slowly

through all of the gear ranges.

5. Shift to P (Park) and leave the engine running.

6. Remove the dipstick, wipe clean with a dry lint free rag.

7. Install and fully seat the dipstick into the filler tube.

8. Remove the dipstick and inspect

the fluid level. Level should be in

the cross-hatched area.

9. If necessary, add fluid in 250ml (1/2 pint) increments through the filler

tube until the level is correct at normal operating temperatures. Refer to

the dipstick or Maintenance and Specifications section for the correct

fluid type. The use of any other non-approved fluid may cause internal

transmission damage.

10. Fluid can be checked at ambient

temperatures between 10–30°C

(50–95°F). DO NOT ADD fluid until

the transmission is at normal

operating temperatures or the transmission will be overfilled.

Low fluid level

Do not drive the vehicle if the fluid

level is at or below the bottom of

the dipstick.

High fluid level

Fluid levels above the safe range

may cause overheating, shift and/or

engagement concerns and internal

transmission damage. If an overfill

condition occurs, excess fluid should

be removed by a qualified technician.

Maintenance and Specifications

174

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 199 200

Pas de commentaire

Ford 2002 Explorer Sport Trac v.2 Manuel d'utilisateur Page 174