Ford 2002 Explorer Sport Trac v.2 Manuel d'utilisateur télécharger pdf (Page 79)

After any vehicle collision, the safety belt systems at all outboard

seating positions (except the driver position, which doesn’t have

this feature) must be checked by a qualified technician to verify that

the automatic locking retractor feature for child seats is still

functioning properly. In addition, all seat belts should be checked for

proper function.

BELT AND RETRACTOR ASSEMBLY MUST BE REPLACED if

the seat belt assembly “automatic locking retractor” feature or

any other seat belt function is not operating properly when checked

according to the procedures in Workshop Manual. Failure to replace

the Belt and Retractor assembly could increase the risk of injury in

collisions.

In this mode, the shoulder belt is automatically pre-locked. The belt will

still retract to remove any slack in the shoulder belt. The automatic

locking mode is not available on the driver safety belt.

This mode should be used any time a child safety seat is installed in a

passenger front or outboard rear seating position (if equipped). Children

12 years old and under should be properly restrained in the rear seat

whenever possible. Refer to Safety restraints for children or Safety

seats for children later in this chapter.

Front safety belt height adjustment

Adjust the height of the shoulder

belt so the belt rests across the

middle of your shoulder.

To adjust the shoulder belt height,

push the button and slide the height

adjuster up or down. Release the

button and pull down on the height

adjuster to make sure it is locked in

place.

Seating and Safety Restraints

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 199 200

Pas de commentaire

Ford 2002 Explorer Sport Trac v.2 Manuel d'utilisateur Page 79