Ford 2012 Fusion v.1 Manuel d'utilisateur télécharger pdf (Page 321)

100

101

Allow the vehicle to sit for at least eight hours without starting the

engine. Then, start the engine and complete the above driving cycle. The

engine must warm up to its normal operating temperature. Once started,

do not turn off the engine until the above driving cycle is complete. If

the vehicle is still not ready for I/M testing, the above driving cycle will

have to be repeated.

POWER STEERING FLUID

Refer to scheduled maintenance information.

• 3.5L V6 engine only

1. Start the engine and let it run until it reaches normal operating

temperature (the engine coolant temperature gauge indicator will be

near the center of the normal area between H and C).

2. While the engine idles, turn the steering wheel left and right several

times.

3. Turn the engine off.

4. Check the fluid level in the reservoir. It should be between the

MIN/MAX or upper and lower lines. Do not add fluid if the level is in this

range.

5. If the fluid is low, add fluid in small amounts, continuously checking

the level until it reaches the range between the MIN/MAX or upper and

lower lines. Be sure to put the cap back on the reservoir. Refer to

Maintenance product specifications and capacities in this chapter for

the proper fluid type.

Maintenance and Specifications

321

2012 Fusion (fsn)

Owners Guide, 1st Printing

USA (fus)

1 2 ... 316 317 318 319 320 321 322 323 324 325 326 ... 374 375

Commentaires sur ces manuels

Pas de commentaire

Ford 2012 Fusion v.1 Manuel d'utilisateur Page 321

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2012 Fusion v.1