Ford 2012 Fusion v.1 Manuel d'utilisateur télécharger pdf (Page 104)

Deactivating/activating autolock feature

Your vehicle comes with the autolock features activated; there are four

methods to enable/disable this feature:

• Through your authorized dealer,

• by using a power door unlock/lock sequence, or

• by using the keyless entry pad (if equipped).

• by using the instrument cluster message center. Refer to Message

center in the Instrument Cluster chapter.

Note: The autolock feature can be activated/deactivated independently

of the autounlock feature.

Power door unlock/lock procedure

Before starting, ensure the ignition is in the off position and all vehicle

doors are closed. You must complete Steps 1–5 within 30 seconds or the

procedure will have to be repeated. If the procedure needs to be

repeated, wait a minimum of 30 seconds before beginning again.

1. Place the key in the ignition and

turn the ignition to the on position.

2. Press the power door unlock

control on the door panel three

times.

3. Turn the ignition from the on

position to the off position.

4. Press the power door unlock control on the door panel three times.

5. Turn the ignition back to the on position. The horn will chirp one time

to confirm programming mode has been entered and is active.

6. To enable/disable the autolock feature, press the unlock control, then

press the lock control. The horn will chirp once if autolock was

deactivated or twice (one short and one long chirp) if autolock was

activated.

7. Turn the ignition to the off position. The horn will chirp once to

confirm the procedure is complete.

Locks and Security

104

2012 Fusion (fsn)

Owners Guide, 1st Printing

USA (fus)

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 374 375

Pas de commentaire

Ford 2012 Fusion v.1 Manuel d'utilisateur Page 104