Ford 2011 Taurus v.2 Manuel d'utilisateur télécharger pdf (Page 63)

4. Turn the headlamp control to the autolamp position. The headlamps

will turn on.

5. Wait the desired amount of time for the exit delay you want (up to

three minutes), then turn the headlamps off.

You can also use the message center to program the autolamp exit time

delay. See Message center in the Instrument Cluster chapter.

High beams

Push the lever toward the

instrument panel to activate. Pull

the lever towards you to deactivate.

Auto high beams (if equipped)

During nighttime driving, the automatic high beam system automatically

turns on your high beams if it is dark enough and no other traffic is

present. When it detects an approaching vehicle’s headlights or a

preceding vehicle’s tail lamps, the system turns off the high beams (low

beams remain on) before they distract other drivers.

If the vehicle is equipped with automatic high beams, the high beam switch

will operate differently depending on the status of the automatic high beam

system. Each of the possible operating scenarios are detailed below:

Scenario 1:

Conditions - The automatic high beam system is set to ON in the

message center. The headlamp switch is in

(autolamps). The

automatic high beam system has turned the high beams on.

Operation - The high beam switch will not perform any function.

Scenario 2:

Conditions - The automatic high beam system is set to ON in the

message center. The headlamp switch is in

(autolamps). The

automatic high beam system has not turned the high beams on.

Operation - The high beam switch can be used to turn the high beams

on. They will then remain on until the switch has been returned to the

neutral position and the auto high beam system has turned the high

beams off.

Lights

2011 Taurus

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 403 404

Pas de commentaire

Ford 2011 Taurus v.2 Manuel d'utilisateur Page 63