Ford 2011 Taurus v.2 Manuel d'utilisateur télécharger pdf (Page 354)

The OBD-II system is designed to check the emission control system

during normal driving. A complete check may take several days. If the

vehicle is not ready for I/M testing, the following driving cycle consisting

of mixed city and highway driving may be performed:

15 minutes of steady driving on an expressway/highway followed by

20 minutes of stop-and-go driving with at least four 30-second idle

periods.

Allow the vehicle to sit for at least eight hours without starting the

engine. Then, start the engine and complete the above driving cycle. The

engine must warm up to its normal operating temperature. Once started,

do not turn off the engine until the above driving cycle is complete. If

the vehicle is still not ready for I/M testing, the above driving cycle will

have to be repeated.

POWER STEERING FLUID (EXCEPT SHO ENGINE)

Refer to scheduled maintenance information.

1. Start the engine and let it run

until it reaches normal operating

temperature (the engine coolant

temperature gauge indicator will be

near the center of the normal area

between H and C).

2. While the engine idles, turn the

steering wheel left and right several

times.

3. Turn the engine off.

4. Check the fluid level in the reservoir. It should be between the MIN

and MAX lines. Do not add fluid if the level is in this range.

5. If the fluid is low, add fluid in small amounts, continuously checking

the level until it reaches the range between the MIN and MAX lines. Be

sure to put the cap back on the reservoir. Refer to Maintenance

product specifications and capacities in this chapter for the proper

fluid type.

Maintenance and Specifications

354

2011 Taurus

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 349 350 351 352 353 354 355 356 357 358 359 ... 403 404

Pas de commentaire

Ford 2011 Taurus v.2 Manuel d'utilisateur Page 354