Ford 2011 Taurus v.2 Manuel d'utilisateur télécharger pdf (Page 134)

Intelligent access keys (if equipped)

You must have two previously programmed intelligent access keys inside

the vehicle and the new unprogrammed intelligent access keys readily

accessible. If two previously programmed keys are not available, you

must take your vehicle to your authorized dealer to have the spare

key(s) programmed.

Note: A maximum of four intelligent access keys can be programmed to

your vehicle. If you would like to replace a previously programmed

access key with a new access key, or if you already have four access keys

programmed to your vehicle, you must take your vehicle and all access

keys to your authorized dealer to be erased and reprogrammed.

Ensure that the vehicle is off before beginning this procedure. Ensure

that all doors are closed before beginning this procedure and that all

doors remain closed throughout the procedure. Perform this procedure

exactly as described below, and perform all steps within 30 seconds of

starting the sequence. If any steps are performed out of sequence, stop

and wait for at least one minute before starting again.

Please read and understand the entire procedure before you begin.

1. Place the new unprogrammed intelligent access key in the pocket

inside the center console utility compartment.

2. Press the driver or passenger power door unlock control three times.

3. Press and release the brake pedal one time.

4. Press the driver or passenger power door lock control three times.

5. Press and release the brake pedal one time. The indicator on the

Start/Stop button should begin to rapidly flash, indicating that

programming mode has been entered and two programmed intelligent

access keys have been detected in the vehicle.

6. Within one minute, press the start/stop button. A message will be

displayed on the message center indicating that the new intelligent

access key was programmed. If four intelligent access keys have already

been programmed to your vehicle, you cannot program anymore and the

message MAX # OF KEYS LEARNED will be displayed on the message

center.

7. Remove the intelligent access key from utility compartment pocket

and press the

or control on the newly programmed intelligent

access keys to exit programming mode.

Locks and Security

134

2011 Taurus

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 403 404

Pas de commentaire

Ford 2011 Taurus v.2 Manuel d'utilisateur Page 134