Ford 2011 Crown Victoria v.3 Manuel d'utilisateur télécharger pdf (Page 61)

WARNING: Handle a halogen headlamp bulb carefully and keep

out of children’s reach. Grasp the bulb only by its plastic base

and do not touch the glass. The oil from your hand could cause the

bulb to break the next time the headlamps are operated.

Note: If the bulb is accidentally touched, it should be cleaned with

rubbing alcohol before being used.

Note: The headlamp bulb should not be removed from the headlamp

until just before a replacement bulb is installed. Removing the bulb for

an extended period of time may affect headlamp bulb performance.

Contaminants may enter the headlamp where they can settle on the lens

and reflector. Never turn the headlamps on with the bulb removed.

Replacing front parking/cornering/turn signal lamp bulbs

To remove the parking/cornering/turn signal lamp bulbs:

1. Make sure the headlamp switch is in the off position, then open the

hood.

2. Remove the three pin type retainers and the radiator shield.

3. Remove two nuts from the back

side of the lamp assembly, then pull

the lamp assembly away from the

vehicle.

4. Rotate the bulb socket

counterclockwise and remove it

from the lamp assembly.

5. Carefully pull bulb straight out of

the socket and push in the new

bulb.

6. To install, reverse the order of

the removal procedure.

Lights

2011 Crown Victoria (cro)

Owners Guide, 3rd Printing

USA (fus)

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 332 333

Pas de commentaire

Ford 2011 Crown Victoria v.3 Manuel d'utilisateur Page 61