Ford 2011 Crown Victoria v.3 Manuel d'utilisateur télécharger pdf (Page 58)

100

101

5. Rotate the bulb socket

counterclockwise and remove from

lamp assembly.

6. Carefully pull bulb straight out of

the socket and push in the new bulb

until it snaps, locking it into

position.

7. To complete installation, follow

the removal procedure in reverse

order.

Replacing tail/brake/turn signal lamp bulbs

The tail lamp and brake/turn signal lamp bulbs are located in the tail

lamp assembly. Follow the same steps to replace either bulb.

1. Make sure the headlamp switch is

in the off position, then open the

trunk and remove the retainer.

2. Carefully pull the carpet away to

expose the lamp assembly hardware.

3. Remove three nuts and the lamp

assembly from the vehicle.

4. Remove the bulb socket by

rotating it counterclockwise, then

pulling it out of the lamp assembly.

5. Pull the bulb from the socket and

push in the new bulb.

6. Install the bulb socket into the

lamp assembly by rotating it

clockwise.

7. Install the lamp assembly on the

vehicle with three nuts ensuring the

nuts are flush with the body to

prevent water from entering the trunk.

Lights

2011 Crown Victoria (cro)

Owners Guide, 3rd Printing

USA (fus)

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 332 333

Commentaires sur ces manuels

Pas de commentaire

Ford 2011 Crown Victoria v.3 Manuel d'utilisateur Page 58

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2011 Crown Victoria v.3