Ford 2010 Fusion Hybrid v.3 Manuel d'utilisateur télécharger pdf (Page 282)

5. Step on the accelerator to start the engine. While the engine is

running, shift the vehicle to neutral.

6. Allow the vehicle to run for at least one minute by pressing on the

accelerator pedal.

7. Drive the vehicle to complete the relearning process.

• The vehicle may need to be driven 10 miles (16 km) or more to

relearn the idle and fuel trim strategy.

• If you do not allow the engine to relearn its idle trim, the idle

quality of your vehicle may be adversely affected until the idle

trim is eventually relearned.

If the battery has been disconnected or a new battery has been installed,

the clock and the preset radio stations must be reset once the battery is

reconnected.

• Always dispose of automotive

batteries in a responsible manner.

Follow your local authorized

standards for disposal. Call your

local authorized recycling center

to find out more about recycling

automotive batteries.

Low and high voltage battery – storage

Your vehicle must be started and run for a minimum of 10 minutes once

a month in order to maintain the high voltage battery charge. This will

maintain the high voltage battery but it is not enough to maintain the

low voltage (underhood) battery and additional low voltage (underhood)

battery charging may be required after 60 days.

If your vehicle is to be stored for 30 days or longer, the low voltage

(underhood) battery negative terminal must be disconnected. Failure to

do this could damage your vehicle’s batteries.

ENGINE COOLANT AND MOTOR/ELECTRONICS COOLANT

Your vehicle is equipped with two separate coolant systems. One is for

engine cooling and the other is for various electric motors and other

components that are specific to the hybrid operating systems.

RETURN

RECYCLE

Maintenance and Specifications

282

2010 Fusion Hybrid (hfv)

Owners Guide, 3rd Printing

USA (fus)

1 2 ... 277 278 279 280 281 282 283 284 285 286 287 ... 328 329

Pas de commentaire

Ford 2010 Fusion Hybrid v.3 Manuel d'utilisateur Page 282