Ford 2010 Fusion Hybrid v.3 Manuel d'utilisateur télécharger pdf (Page 279)

• Do not overfill the engine with oil. Oil levels above the upper

hole/line may cause engine damage. If the engine is overfilled,

some oil must be removed from the engine by an authorized dealer.

7. Put the dipstick back in and ensure it is fully seated.

Adding engine oil

1. Check the engine oil. For instructions, refer to Checking the engine

oil in this chapter.

2. If the engine oil level is not within the normal operating range, add

only certified engine oil of the recommended viscosity. Remove the

engine oil filler cap and use a funnel to pour the engine oil into the

opening.

3. Recheck the engine oil level. Make sure the oil level is not above the

normal operating range on the engine oil level dipstick.

4. Install the dipstick and ensure it is fully seated.

5. Fully install the engine oil filler cap by turning the filler cap clockwise

until it stops.

To avoid possible oil loss, DO NOT operate the vehicle with the

engine oil level dipstick and/or the engine oil filler cap removed.

Engine oil and filter recommendations

Look for this certification

trademark.

Use SAE 5W-20 engine oil

Only use oils certified for gasoline engines by the American Petroleum

Institute (API). An oil with this trademark symbol conforms to the

current engine and emission system protection standards and fuel

economy requirements of the International Lubricant Standardization and

Approval Committee (ILSAC), comprised of U.S. and Japanese

automobile manufacturers.

Maintenance and Specifications

279

2010 Fusion Hybrid (hfv)

Owners Guide, 3rd Printing

USA (fus)

1 2 ... 274 275 276 277 278 279 280 281 282 283 284 ... 328 329

Pas de commentaire

Ford 2010 Fusion Hybrid v.3 Manuel d'utilisateur Page 279