Ford 2010 Fusion Hybrid v.3 Manuel d'utilisateur télécharger pdf (Page 222)

If you cannot move the gearshift lever out of P (Park) with ignition in

the on position and the brake pedal pressed, it is possible that a fuse has

blown or the vehicle’s brakelamps are not operating properly. Refer to

Fuses and relays in the Roadside Emergencies chapter.

If the fuse is not blown and the brakelamps are working properly, the

following procedure will allow you to move the gearshift lever from P

(Park):

1. Apply the parking brake, turn the

ignition key to the off position, and

remove the key.

2. Using a screwdriver (or similar

tool), carefully pry off and remove

the chrome trim ring (1) from the

shifter base.

3. Open the storage compartment

lid and carefully pry the trim panel

(2) up from rear attachments on the

storage compartment and disconnect it from the console to expose the

inside of the gearshift.

4. Locate the brake shift interlock

lever on the driver’s side of the

shifter assembly.

5. Apply the brake pedal. Using a

screwdriver (or similar tool), press

and hold the brake shift interlock

lever while pulling the gearshift

lever out of the P (Park) position

and into the N (Neutral) position.

6. Install the trim panel (2) and

chrome ring (1) in reverse order.

7. Apply brake pedal, start the vehicle, and release the parking brake.

See your authorized dealer as soon as possible if this procedure

is used.

WARNING: Do not drive your vehicle until you verify that the

brakelamps are working.

Driving

222

2010 Fusion Hybrid (hfv)

Owners Guide, 3rd Printing

USA (fus)

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 328 329

Pas de commentaire

Ford 2010 Fusion Hybrid v.3 Manuel d'utilisateur Page 222