Ford 2006 Fusion v.2 Manuel d'utilisateur télécharger pdf (Page 239)

Low fluid level

Do not drive the vehicle if the fluid

level does not show at all on the

dipstick.

Driving the vehicle with less than

the recommended fluid level may result in transaxle failure. An under fill

condition of transmission fluid may cause shift and/or engagement

concerns and /or possible damage to the transaxle.

High fluid level

Fluid levels above the normal

operating range may result in

transaxle failure. An overfill

condition of transmission fluid may

cause shift and/or engagement

concerns and/or possible damage to

the transaxle.

High fluid levels can be caused by an overheating condition.

Adjusting automatic transmission fluid levels

Before adding any fluid, make sure the correct type is used. The type of

fluid used is normally indicated on the dipstick and also in the

Lubricant specifications section in this chapter.

Note: Only one ATF fluid specification has been tested and approved for

use with the automatic 6-speed: Premium Automatic Transmission fluid.

Mercon fluids cannot be used with the automatic 6-speed without

damage or voiding warranty.

Use of a non-approved automatic transmission fluid may cause

internal transaxle component damage.

If necessary, add fluid in 1/2 pint (250 mL) increments through the filler

tube until the level is correct.

If an overfill occurs, excess fluid should be removed by an authorized

dealer.

An overfill condition of transmission fluid may cause shift and/or

engagement concerns and/or possible damage.

Do not use supplemental transmission fluid additives, treatments or

cleaning agents. The use of these materials may affect transmission

operation and result in damage to internal transaxle components.

2006 Fusion (fsn)

Owners Guide (post-2002-fmt)

USA (fus)

Maintenance and Specifications

239

1 2 ... 234 235 236 237 238 239 240 241 242 243 244 ... 263 264

Pas de commentaire

Ford 2006 Fusion v.2 Manuel d'utilisateur Page 239