Ford 2006 Fusion v.2 Manuel d'utilisateur télécharger pdf (Page 234)

Readiness for Inspection/Maintenance (I/M) testing

In some localities, it may be a legal requirement to pass an I/M test of

the on-board diagnostics system. If the

indicator is on, refer to the

description in the Warning lights and chimes section of the

Instrument Cluster chapter. Your vehicle may not pass the I/M test with

the

indicator on.

If the vehicle’s powertrain system or its battery has just been serviced,

the on-board diagnostics system is reset to a “not ready for I/M test”

condition. To ready the on-board diagnostics system for I/M testing, a

minimum of 30 minutes of city and highway driving is necessary as

described below:

• First, at least 10 minutes of driving on an expressway or highway.

• Next, at least 20 minutes driving in stop-and-go, city-type traffic with

at least four idle periods.

Allow the vehicle to sit for at least eight hours without starting the

engine. Then, start the engine and complete the above driving cycle. The

engine must warm up to its normal operating temperature. Once started,

do not turn off the engine until the above driving cycle is complete.

POWER STEERING FLUID

Refer to the scheduled maintenance information for the service

interval schedules. If adding fluid is necessary, use only MERCON威 ATF.

• 2.3L I4 Engine

2006 Fusion (fsn)

Owners Guide (post-2002-fmt)

USA (fus)

Maintenance and Specifications

234

1 2 ... 229 230 231 232 233 234 235 236 237 238 239 ... 263 264

Pas de commentaire

Ford 2006 Fusion v.2 Manuel d'utilisateur Page 234