Ford 2006 Freestar v.2 Manuel d'utilisateur télécharger pdf (Page 302)

7. Remove the dipstick and inspect the fluid level. The fluid should be in

the designated areas for normal operating temperature.

Low fluid level

Do not drive the vehicle if the fluid

level is at the bottom of the dipstick

and the outside temperatures are

above 50°F (10°C).

Correct fluid level

The transmission fluid should be checked at normal operating

temperatures 150°F-170°F (66°C-77°C) on a level surface. The normal

operating temperature can be reached after approximately 20 miles (30

km) of driving.

The transmission fluid should be in

this range if at normal operating

temperature (150°F-170°F

[66°C-77°C]).

High fluid level

Fluid levels above the safe range

may result in transaxle failure. An

overfill condition of transmission

fluid may cause shift and/or

engagement concerns and/or possible damage.

High fluid levels can be caused by an overheating condition.

Adjusting automatic transmission fluid levels

Before adding any fluid, make sure the correct type is used. The type of

fluid used is normally indicated on the dipstick and also in the

Lubricant specifications section in this chapter.

Use of a non-approved automatic transmission fluid may cause

internal transaxle component damage.

If necessary, add fluid in 1/2 pint (250 mL) increments through the filler

tube until the level is correct.

If an overfill occurs, excess fluid

should be removed by a qualified

technician.

An overfill condition of

transmission fluid may cause shift and/or engagement concerns

and/or possible damage.

2006 Freestar (win)

Owners Guide (post-2002-fmt)

USA (fus)

Maintenance and Specifications

302

1 2 ... 297 298 299 300 301 302 303 304 305 306 307 ... 327 328

Pas de commentaire

Ford 2006 Freestar v.2 Manuel d'utilisateur Page 302