Ford 2006 Freestar v.2 Manuel d'utilisateur télécharger pdf (Page 47)

• In order to turn off the domelamp, rotate the thumbwheel to the left.

The dome lamp will not illuminate if the control switch is in the OFF

position.

AIMING THE HEADLAMPS

The headlamps on your vehicle are properly aimed at the assembly plant.

If your vehicle has been in an accident the alignment of your headlamps

should be checked by your authorized dealer.

You will need a #2 Phillips screwdriver to make the adjustments.

Vertical aim adjustment

1. Park the vehicle directly in front of a wall or screen on a level surface,

approximately 25 feet (7.6 meters) away.

• (1) 8 feet (2.4 meters)

• (2) Center height of lamp to

ground

• (3) 25 feet (7.6 meters)

• (4) Horizontal reference line

2. Measure the height from the

center of your headlamp to the

ground and mark an 8 foot (2.4

meter) horizontal reference line on

the vertical wall or screen at this

height (a piece of masking tape works well). The center of the lamp is

marked by a 0.5 mm circle on the headlamp lens.

3. Turn on the low beam headlamps to illuminate the wall or screen and

open the hood.

4. On the wall or screen you will

observe a light pattern with high

intensity flat segments at the top

edge of the pattern. If the flat edges

are not at the horizontal reference

line, the beam will need to be

adjusted.

2006 Freestar (win)

Owners Guide (post-2002-fmt)

USA (fus)

Lights

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 327 328

Pas de commentaire

Ford 2006 Freestar v.2 Manuel d'utilisateur Page 47