Ford 2006 Expedition v.1 Manuel d'utilisateur télécharger pdf (Page 122)

• Continue to press and hold the HomeLink威 button (note Step 3 in the

“Programming” section) while you press and release — every two

seconds (“cycle”) your hand-held transmitter until the frequency

signal has been accepted by the HomeLink威. The indicator light will

flash slowly and then rapidly after HomeLink威 accepts the radio

frequency signal.

• Proceed with Step 4 in the “Programming” section.

Operating the HomeLink姞 Wireless Control System

To operate, simply press and release

the appropriate HomeLink威 button.

Activation will now occur for the

trained product (garage door, gate

operator, security system, entry

door lock, or home or office lighting

etc.). For convenience, the

hand-held transmitter of the device

may also be used at any time. In the event that there are still

programming difficulties, contact HomeLink威 at www.homelink.com or

1–800–355–3515.

Erasing HomeLink姞 buttons

To erase the three programmed

buttons (individual buttons cannot

be erased):

• Press and hold the two outer

HomeLink威 buttons until the

indicator light begins to

flash-after 20 seconds. Release

both buttons. Do not hold for

longer that 30 seconds.

HomeLink威 is now in the train (or

learning) mode and can be programmed at any time beginning with Step

2inthe“Programming” section.

Reprogramming a single HomeLink姞 button

To program a device to HomeLink威 using a HomeLink威 button previously

trained, follow these steps:

1. Press and hold the desired HomeLink威 button. Do NOT release the

button.

2006 Expedition (exd)

Owners Guide (post-2002-fmt)

USA (fus)

Driver Controls

122

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 359 360

Pas de commentaire

Ford 2006 Expedition v.1 Manuel d'utilisateur Page 122