Ford 2006 Expedition v.1 Manuel d'utilisateur télécharger pdf (Page 335)

Allow the vehicle to sit for at least eight hours without starting the

engine. Then, start the engine and complete the above driving cycle. The

engine must warm up to its normal operating temperature. Once started,

do not turn off the engine until the above driving cycle is complete.

POWER STEERING FLUID

Check the power steering fluid. Refer to the scheduled maintenance

information for the service interval schedules. If adding fluid is

necessary, use only Ford Premium Power Steering Fluid or MERCON威

ATF.

1. Start the engine and let it run

until it reaches normal operating

temperature (the engine coolant

temperature gauge indicator will be

near the center of the normal area

between H and C).

2. While the engine idles, turn the

steering wheel left and right several

times.

3. Turn the engine off.

4. Check the fluid level in the reservoir. It should be between the MIN

and MAX lines. Do not add fluid if the level is in this range.

5. If the fluid is low, add fluid in small amounts, continuously checking

the level until it reaches the range between the MIN and MAX lines. Be

sure to put the cap back on the reservoir.

BRAKE FLUID

The fluid level will drop slowly as

the brakes wear, and will rise when

the brake components are replaced.

Fluid levels between the “MIN” and

“MAX” lines are within the normal

operating range; there is no need to

add fluid. If the fluid levels are

outside of the normal operating

range the performance of your

brake system could be

compromised; seek service from

your authorized dealer immediately.

2006 Expedition (exd)

Owners Guide (post-2002-fmt)

USA (fus)

Maintenance and Specifications

335

1 2 ... 330 331 332 333 334 335 336 337 338 339 340 ... 359 360

Pas de commentaire

Ford 2006 Expedition v.1 Manuel d'utilisateur Page 335