Ford 2004 Expedition v.3 Manuel d'utilisateur télécharger pdf (Page 92)

PANEL DIMMER CONTROL

Use to adjust the brightness of the

instrument panel and all applicable

switches in the vehicle during

headlamp and parklamp operation.

Move the control to the full upright

position, past detent, to turn on the

interior lamps.

Move the control to the full down

position, past detent, to prevent the interior lights from illuminating

when the doors are opened.

VERTICAL AIM ADJUSTMENT

1. Park the vehicle on a level surface approximately 7.6 meters (25 feet)

from a vertical wall or screen directly in front of it.

• (1) Eight feet

• (2) Center height of lamp to ground

• (3) Twenty-five feet

• (4) Horizontal reference line

2. Measure the height from the

center of your headlamp (indicated

by a 3.0 mm circle on the lens) to

the ground and mark a 2.4 meter (8

foot) horizontal reference line on

the vertical wall or screen at this

height (a piece of masking tape

works well).

3. Turn on the low beam headlamps

to illuminate the wall or screen and open the hood. Cover one of the

headlamps so no light hits the wall.

4. On the wall or screen you will

observe a light pattern with a

distinct horizontal edge towards the

right. If this edge is not at the

horizontal reference line, the beam will need to be adjusted so the edge

is at the same height as the horizontal reference line.

2004 Expedition (exd)

Owners Guide (post-2002-fmt)

USA English (fus)

Lights

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 359 360

Pas de commentaire

Ford 2004 Expedition v.3 Manuel d'utilisateur Page 92