Ford 2011 Crown Victoria v.2 Manuel d'utilisateur télécharger pdf (Page 279)

8. Left front tire: Place the TPMS reset tool against the left front tire

where the tire meets the rim, opposite from the valve stem (1) as shown.

This is where the sensor is located inside the rim.

Both tools, the TPMS training tool (part number 8C2Z-1A203-A)

or the Tire Pressure Monitor Activation Tool (part number

204-363), must be held against the tire sidewall opposite the

valve stem as illustrated. For the TPMS training tool, the device

should be held as illustrated, with the arrow on the tool pointing

towards the rim; do not use the tool with the arrow pointing away

from the rim as it may not activate the sensor.

9. Press and release the activation button while holding either tool to the

side wall until the horn sounds. The horn will sound once within

approximately 10 seconds to indicate the process was successful.

Note:

• If a double horn chirp is heard, repeat the procedure. If a single horn

chirp is not heard, move the vehicle to rotate the wheels at least a

⁄

-turn and repeat the procedure starting with Step 1.

• If the horn does not sound while attempting to reset any wheel, seek

service from your authorized dealer.

10. Perform Steps 8 and 9 on the right front tire, right rear tire and

finally the left rear tire. Training is complete after the horn sounds for

the last tire trained (left rear tire).

Turn the ignition to off. If two short horn beeps are heard, the reset

procedure was unsuccessful and must be repeated.

Crown Victoria Severe Duty

279

2011 Crown Victoria (cro)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 274 275 276 277 278 279 280 281 282 283 284 ... 330 331

Pas de commentaire

Ford 2011 Crown Victoria v.2 Manuel d'utilisateur Page 279