Ford 2010 Crown Victoria v.2 Manuel d'utilisateur télécharger pdf (Page 50)

• (1) 8 feet (2.4 meters)

• (2) Center height of lamp to

ground

• (3) 25 feet (7.6 meters)

• (4) Horizontal reference line

• (5) Center of headlamps

• (6) Center line of the vehicle

2. The center of the headlamp is

marked either on the lens (a circle

or cross marker) or on the bulb shield, internal to the lamp (mark or

feature). Measure the height from the center of your headlamp to the

ground (2) and mark an 8 foot (2.4 meter) long horizontal line on the

wall or screen (1) at this height (masking tape works well).

3. Turn on the low beam headlamps

and open the hood.

4. Locate the high intensity area of

the beam pattern and place the top

edge of the intensity zone even with

the horizontal reference line (4). If

the top edge of the high intensity

area is not even with the horizontal

line, follow the next step to adjust

it.

5. Locate the vertical adjuster for

each headlamp. Adjust the aim by

turning the adjuster control either

clockwise (to adjust down) or

counterclockwise (to adjust up).

6. In addition to the horizontal line

marked in step 2, a pair of vertical

lines (5) must be marked at the

center line of the headlamps on the

wall or screen.

7. On the wall or screen, locate the

high intensity area of the beam pattern. The left edge of the high

intensity area should be even with the vertical line corresponding to the

headlamp under adjustment. If the left edge of the high intensity area is

not even with the vertical line, follow the next step to adjust it.

Lights

2010 Crown Victoria (cro)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 307 308

Pas de commentaire

Ford 2010 Crown Victoria v.2 Manuel d'utilisateur Page 50