Ford 2010 Crown Victoria v.2 Manuel d'utilisateur télécharger pdf (Page 58)

100

101

Replacing tail/brake/turn signal lamp bulbs

The tail lamp and brake/turn signal lamp bulbs are located in the tail

lamp assembly. Follow the same steps to replace either bulb.

1. Make sure the headlamp switch is

in the off position, then open the

trunk and remove the retainer.

2. Carefully pull the carpet away to

expose the lamp assembly hardware.

3. Remove three nuts and the lamp

assembly from the vehicle.

4. Remove the bulb socket by

rotating it counterclockwise, then

pulling it out of the lamp assembly.

5. Pull the bulb from the socket and

push in the new bulb.

6. Install the bulb socket into the

lamp assembly by rotating it

clockwise.

7. Install the lamp assembly on the

vehicle with three nuts ensuring the

nuts are flush with the body to

prevent water from entering the trunk.

8. Carefully push the carpet back in to place and install the retainer.

Lights

2010 Crown Victoria (cro)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 307 308

Commentaires sur ces manuels

Pas de commentaire

Ford 2010 Crown Victoria v.2 Manuel d'utilisateur Page 58

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2010 Crown Victoria v.2