Ford 2010 Crown Victoria v.2 Manuel d'utilisateur télécharger pdf (Page 82)

Replacing the battery

The remote entry transmitter uses one coin type three-volt lithium

battery CR2032 or equivalent.

To replace the battery:

1. Twist a thin coin between the two

halves of the remote entry

transmitter near the key ring. DO

NOT TAKE THE RUBBER COVER

AND CIRCUIT BOARD OFF THE

FRONT HOUSING OF THE

REMOTE ENTRY TRANSMITTER.

2. Do not wipe off any grease on the

battery terminals on the back

surface of the circuit board.

3. Remove the old battery.

Note: Please refer to local

regulations when disposing of

transmitter batteries.

4. Insert the new battery. Refer to

the diagram inside the remote entry

transmitter for the correct

orientation of the battery. Press the battery down to ensure that the

battery is fully seated in the battery housing cavity.

5. Snap the two halves back together.

Note: Replacement of the battery will not cause the remote transmitter

to become deprogrammed from your vehicle. The remote transmitter

should operate normally after battery replacement.

Replacing lost transmitters

Take all your vehicle’s transmitters to your authorized dealer if service is

required.

If a remote transmitter has been lost and you would like to remove it

from the vehicle’s memory, or you would like to purchase additional

remote transmitters and have them programmed to your vehicle:

• Take all your vehicle’s transmitters to your authorized dealer for

programming, or

Locks and Security

2010 Crown Victoria (cro)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 307 308

Pas de commentaire

Ford 2010 Crown Victoria v.2 Manuel d'utilisateur Page 82