Ford 2010 Crown Victoria v.2 Manuel d'utilisateur télécharger pdf (Page 258)

4. Check the fluid level in the

reservoir. It should be between the

MIN and MAX lines. Do not add

fluid if the level is in this range.

5. If the fluid is low, add fluid in small amounts, continuously checking

the level until it reaches the range between the MIN and MAX lines. Be

sure to put the cap back on the reservoir. Refer to Maintenance

product specifications and capacities in this chapter for the proper

fluid type.

BRAKE FLUID

The fluid level will drop slowly as

the brakes wear, and will rise when

the brake components are replaced.

Fluid levels below the MAX line that

do not trigger the brake system

warning lamp are within the normal

operating range, there is no need to

add fluid. If the fluid levels are outside of the normal operating range,

the performance of your brake system could be compromised, seek

service from your authorized dealer immediately.

TRANSMISSION FLUID

Checking automatic transmission fluid (if equipped)

Refer to your scheduled maintenance information for scheduled

intervals for fluid checks and changes. Your transmission does not

consume fluid. However, the fluid level should be checked if the

transmission is not working properly, i.e., if the transmission slips or

shifts slowly or if you notice some sign of fluid leakage.

Automatic transmission fluid expands when warmed. To obtain an

accurate fluid check, drive the vehicle until it is at normal operating

temperature (approximately 20 miles [30 km]). If your vehicle has been

operated for an extended period at high speeds, in city traffic during hot

weather or pulling a trailer, the vehicle should be turned off for about

30 minutes to allow fluid to cool before checking.

MAX

MIN

Maintenance and Specifications

258

2010 Crown Victoria (cro)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 253 254 255 256 257 258 259 260 261 262 263 ... 307 308

Pas de commentaire

Ford 2010 Crown Victoria v.2 Manuel d'utilisateur Page 258