Ford 2004 Excursion v.1 Manuel d'utilisateur télécharger pdf (Page 96)

The compass reading may be affected when you drive near large

buildings, bridges, power lines and powerful broadcast antenna. Magnetic

or metallic objects placed in or on the vehicle may also affect compass

accuracy. Adjustments may need to be made to the zone and calibration

of the compass.

Compass zone adjustment

1. Determine which magnetic zone

you are in for your geographic

location by referring to the zone

map.

2. Locate the trip computer on the

overhead console.

3. Turn ignition to the ON position.

4. Press and hold both trip

computer controls. After

approximately four seconds, the trip

computer will enter zone setting

mode. Zone setting mode is

indicated when the display lights the

“ZONE” indicator.

5. Release both controls.

Subsequent pressing of either

control will increment the zone.

Press the control repeatedly until

the correct zone setting for your geographic location is displayed on the

trip computer.

6. To exit the zone setting mode and save the displayed zone in memory,

release both controls for greater than five seconds.

Compass calibration adjustment

Perform this adjustment in an open area free from steel structures and

high voltage lines.

For optimum calibration, turn off all electrical accessories (heater/air

conditioning, wipers, etc.) and make sure all vehicle doors are shut.

1. Locate the trip computer located in the overhead console.

2. Start the vehicle.

RESET

MODE

E/M

Driver Controls

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 271 272

Pas de commentaire

Ford 2004 Excursion v.1 Manuel d'utilisateur Page 96