Ford 2004 Excursion v.1 Manuel d'utilisateur télécharger pdf (Page 108)

The UNLOCK function will operate again after you unlock the vehicle

using the remote entry transmitter or key pad, turn the ignition to ON,

or open the door from inside of the vehicle.

Power door unlock disable feature — activation/deactivation

1. Turn the ignition key to ON.

2. Press the UNLOCK button 3 times.

3. Turn the ignition key to OFF.

4. Press the UNLOCK button 3 times.

5. Turn the ignition key to ON. The horn will chirp.

6. Press the LOCK button 2 times. You should receive 2 horn chirps to

indicate the system has been disabled, or 2 chirps followed by a honk to

indicate the system has been enabled.

Note: Pressing the power door LOCK button two times again will turn

the feature ON if it was previously OFF, or OFF if it was previously ON.

Every two consecutive presses of the LOCK button after successfully

entering the configuration mode will change the enable/disable condition

of the feature.

7. Turn ignition to OFF to exit programming. The horn will chirp once to

confirm the procedure is complete.

Sounding a panic alarm

Press this control to activate the

alarm.

To deactivate the alarm, press the

control again or turn the ignition to

ACC or ON.

Panic alarm will only operate with

the ignition in the OFF position.

Replacing the battery

The remote transmitter is powered by one coin type three-volt lithium

battery CR2032 or equivalent. Typical operating range will allow you to

be up to 10 meters (33 feet) away from your vehicle. A decrease in

operating range can be caused by the following factors:

• Weather conditions

Locks and Security

108

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 271 272

Pas de commentaire

Ford 2004 Excursion v.1 Manuel d'utilisateur Page 108