Ford 2004 Excursion v.1 Manuel d'utilisateur télécharger pdf (Page 247)

Adjusting automatic transmission fluid levels

Before adding any fluid, make sure the correct type is used. The type of

fluid used is normally indicated on the dipstick and also in the

Lubricant specifications section in this chapter.

Use of a non-approved automatic transmission fluid may cause

internal transmission component damage.

If necessary, add fluid in 250 ml (1/2 pint) increments through the filler

tube until the level is correct.

If an overfill occurs, excess fluid

should be removed by a qualified

technician.

An overfill condition of

transmission fluid may cause

shift and/or engagement

concerns and/or possible

damage.

Do not use supplemental transmission fluid additives, treatments or

cleaning agents. The use of these materials may affect transmission

operation and result in damage to internal transmission components.

Checking and adding transfer case fluid (if equipped)

1. Clean the filler plug.

2. Remove the filler plug and

inspect the fluid level.

ADD COLD HOT DO NOT ADD

DON'T ADD IF IN CROSSHATCHED AREA • CHECK WHEN HOT IDLING IN PARK

Maintenance and Specifications

247

1 2 ... 242 243 244 245 246 247 248 249 250 251 252 ... 271 272

Pas de commentaire

Ford 2004 Excursion v.1 Manuel d'utilisateur Page 247