Ford 2003 Ranger v.2 Manuel d'utilisateur télécharger pdf (Page 79)

Insert the tongue into the correct

buckle (the buckle closest to the

direction the tongue is coming

from). To lengthen the belt, turn the

tongue at a right angle to the belt

and pull across your lap until it

reaches the buckle. To tighten the

belt, pull the loose end of the belt

through the tongue until it fits snugly across the hips.

Shorten and fasten the belt when

not in use.

Adjusting the rear center facing jump seat lap belt (if equipped)

The lap belt will adjust automatically. To fasten, grasp the tongue, and

with a continuous motion, pull out enough webbing to buckle the tongue

into the correct buckle. If you did not pull out enough webbing to reach

the buckle, allow the tongue to retract fully before trying to pull it out

again.

The lap belt should fit snugly and as low as possible around the

hips, not across the waist.

If you need to lengthen the belt, unfasten it and repeat the procedure

above.

To unfasten the belt, push in the release button prior to opening the rear

door.

Seating and Safety Restraints

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 247 248

Pas de commentaire

Ford 2003 Ranger v.2 Manuel d'utilisateur Page 79