Ford 2003 Ranger v.2 Manuel d'utilisateur télécharger pdf (Page 102)

7. Pull the lap belt portion across

the child seat toward the buckle and

pull up on the shoulder belt while

pushing down with knee on the

child seat.

8. Allow the safety belt to retract to

remove any slack in the belt.

9. Before placing the child in the

seat, forcibly tilt the seat forward

and back to make sure the seat is

securely held in place. To check

this, grab the seat at the belt path

and attempt to move it side to side

and forward. There should be no

more than one inch of movement for

proper installation.

10. Try to pull the belt out of the retractor to make sure the retractor is

in the automatic locking mode (you should not be able to pull more belt

out). If the retractor is not locked, unbuckle the belt and repeat steps

two through nine.

Check to make sure the child seat is properly secured before each use.

Attaching child safety seats with tether straps

Most new forward-facing child safety seats include a tether strap which

goes over the back of the seat and hooks to an anchoring point. Tether

straps are available as an accessory for many older safety seats. Contact

the manufacturer of your child seat for information about ordering a

tether strap.

The tether anchors in your vehicle are located on the back of the front

seat cushion.

The tether strap anchors in your vehicle are in the following positions

(shown from top view):

Seating and Safety Restraints

102

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 247 248

Pas de commentaire

Ford 2003 Ranger v.2 Manuel d'utilisateur Page 102