Ford 2003 Ranger v.2 Manuel d'utilisateur télécharger pdf (Page 70)

1. Insert a previously programmed

coded key into the ignition.

2. Turn the ignition from the 3

(OFF) position to the 4 (ON)

position. Keep the ignition in the 4

(ON) position for at least one

second, but no more than 10

seconds.

3. Turn the ignition to the 3 (OFF)

position, and remove the coded key

from the ignition.

4. Within ten seconds of removing the previously programmed coded key,

insert the other previously programmed coded key into the ignition.

5. Turn the ignition from the 3 (OFF) position to the 4 (ON) position.

Keep the ignition in the 4 (ON) position for at least one second but not

more than 10 seconds.

6. Turn the ignition to the 3 (OFF) position, and remove the second key

from the ignition.

7. Within twenty seconds of removing the previously programmed coded

key, insert the unprogrammed key (new/valet key) into the ignition.

8. Turn the ignition from the 3 (OFF) position to the 4 (ON) position.

Keep the ignition in the 4 (ON) position for at least one second.

9. Your new unprogrammed key is now programmed.

If the key has been successfully programmed it will start the vehicle’s

engine and the theft indicator light will illuminate for three seconds and

then go out. If the key was not successfully programmed, it will not start

your vehicle’s engine and the theft indicator light will flash on and off

rapidly. If failure repeats, bring your vehicle to your dealer to have the

new key(s) programmed.

To program additional new unprogrammed key(s), repeat this procedure

from step 1 for each additional key.

Locks and Security

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 247 248

Pas de commentaire

Ford 2003 Ranger v.2 Manuel d'utilisateur Page 70