Ford 2003 F-150 v.2 Manuel d'utilisateur télécharger pdf (Page 235)

Allow the vehicle to sit for at least eight hours without starting the

engine. Then, start the engine and complete the above driving cycle. The

engine must warm up to its normal operating temperature. Once started,

do not turn off the engine until the above driving cycle is complete.

CHECKING AND ADDING POWER STEERING FLUID

Check the power steering fluid.

Refer to the scheduled maintenance

guide for the service interval

schedules. If adding fluid is

necessary, use only MERCON威 ATF.

1. Start the engine and let it run until it reaches normal operating

temperature (the engine coolant temperature gauge indicator will be

near the center of the normal area between H and C).

2. While the engine idles, turn the steering wheel left and right several

times.

3. Turn the engine off.

4. Check the fluid level in the

reservoir. It should be between the

MIN and MAX lines. Do not add

fluid if the level is in this range.

5. If the fluid is low, add fluid in small amounts, continuously checking

the level until it reaches the range between the MIN and MAX lines. Be

sure to put the cap back on the reservoir.

Maintenance and Specifications

235

1 2 ... 230 231 232 233 234 235 236 237 238 239 240 ... 271 272

Pas de commentaire

Ford 2003 F-150 v.2 Manuel d'utilisateur Page 235