Ford 2003 F-150 v.2 Manuel d'utilisateur télécharger pdf (Page 70)

To stow the bed extender, follow steps one through four in reverse order.

The bed extender may be used to secure a load of up to 46 kg (100 lbs.)

on the tailgate.

The bed extender should always be kept in the stowed position

with the tailgate closed when not in use.

To remove the bed extender:

1. Extend the bed extender.

2. Pull the round knobs on each side

of the extender to unlock it.

Make sure the locking clip screws

are loose before removing the

extender.

1. Press the locking clips below the

middle bar on each side and lift the

extender out of the bed.

To install the bed extender, follow the removal procedure in reverse

order.

TONNEAU COVER (IF EQUIPPED)

The tonneau cover has been designed to maximize fuel economy and

should be fully installed whenever possible.

The cover can be rolled up and stowed behind the cab, or removed

completely from the vehicle.

• To avoid damage to the cover, do not operate the vehicle unless the

cover is fully installed, or securely stowed.

The removal and stowage for styleside and flareside vehicles are basically

the same except where noted.

To remove or stow the cover:

1. Styleside only: In cold weather lower tailgate and release the levers

on each side of the rear rail to release tension on the cover.

Driver Controls

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 271 272

Pas de commentaire

Ford 2003 F-150 v.2 Manuel d'utilisateur Page 70