Ford 2003 Explorer v.5 Manuel d'utilisateur télécharger pdf (Page 65)

3. Locate compass sensor mounted

at base of mirror.

4. Press the button on the top of

the compass module until ZONE

appears in the instrument cluster

display.

5. Release pressure on the button and then slowly press it down again.

6. Continue to press until ZONE

appears in the instrument cluster

display, then release. The display

should show the current zone

number.

7. Press until the desired zone

number appears. The display will flash and then return to normal

operation. The zone is now updated.

Compass calibration adjustment

Perform this adjustment in an open area free from steel structures and

high voltage lines:

For optimum calibration, turn off all electrical accessories (heater/air

conditioning, wipers, etc.) and make sure all vehicle doors are shut.

1. Start the vehicle.

2. Locate compass sensor mounted at base of mirror.

3. Press the button on the top of

the compass module until ZONE

appears in the instrument cluster

display. Continue to hold down until

ZONE disappears and CAL is

displayed (approximately eight

seconds) and release.

4. Drive the vehicle slowly (less than 5 km/h [3 mph]) in circles until

CAL indicator turns off (4–5 complete circles).

5. The compass is now calibrated.

2003 Explorer (exp)

Owners Guide (post-2002-fmt)

USA English (fus)

Driver Controls

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 279 280

Pas de commentaire

Ford 2003 Explorer v.5 Manuel d'utilisateur Page 65