Ford 2003 Explorer v.5 Manuel d'utilisateur télécharger pdf (Page 235)

When the engine is cold, check the

level of the engine coolant in the

reservoir.

• The engine coolant should be at

the “cold fill level” or within the

“cold fill range” as listed on the

engine coolant reservoir

(depending upon application).

• Refer to the Scheduled

Maintenance Guide for service

interval schedules.

• Be sure to read and understand

Precautions when servicing

your vehicle in this chapter.

If the engine coolant has not been

checked at the recommended

interval, the engine coolant reservoir

may become low or empty. If the

reservoir is low or empty, add

engine coolant to the reservoir.

Refer to Adding engine coolant in this chapter.

Note: Automotive fluids are not interchangeable; do not use engine

coolant, antifreeze or windshield washer fluid outside of its specified

function and vehicle location.

Adding engine coolant

When adding coolant, make sure it is a 50/50 mixture of engine coolant

and distilled water. Add the mixture to the coolant reservoir, when the

engine is cool, until the appropriate fill level is obtained.

Do not add engine coolant when the engine is hot. Steam and

scalding liquids released from a hot cooling system can burn you

badly. Also, you can be burned if you spill coolant on hot engine parts.

Do not put engine coolant in the windshield washer fluid

container. If sprayed on the windshield, engine coolant could

make it difficult to see through the windshield.

• Add Motorcraft Premium Gold Engine Coolant

(yellow-colored), VC-7–A (VC-7–B in Oregon), meeting Ford

Specification WSS-M97B51–A1.

2003 Explorer (exp)

Owners Guide (post-2002-fmt)

USA English (fus)

Maintenance and Specifications

235

1 2 ... 230 231 232 233 234 235 236 237 238 239 240 ... 279 280

Pas de commentaire

Ford 2003 Explorer v.5 Manuel d'utilisateur Page 235