Ford 2003 Explorer v.5 Manuel d'utilisateur télécharger pdf (Page 136)

The lower anchors for child seat

installation are located at the rear

section of the second row seat

between the cushion and seat back.

The LATCH anchors are below the

locator symbols on the seat back.

Follow the child seat manufacturer’s

instructions to properly install a

child seat with LATCH attachments.

Two plastic LATCH guides can be

obtained at no charge from any

Ford or Lincoln-Mercury dealer.

They snap onto the LATCH lower

anchors in the seat to help attach a

child seat with rigid attachments.

The guides hold the seat trim away

to expose the anchor and make it

easier to attach some child seats.

Attach LATCH lower attachments of the child seat only to the

anchors shown.

If you install a child seat with rigid LATCH attachments, do not tighten

the tether strap enough to lift the child seat off the vehicle seat cushion

when the child is seated in it. Keep the tether strap just snug without

lifting the front of the child seat. Keeping the child seat just touching the

vehicle seat gives the best protection in a severe crash.

Each time you use the safety seat, check that the seat is properly

attached to the lower anchors and tether anchor. Try to move the child

seat from side to side. Also try to tug the seat forward. Check to see if

the anchors hold the seat in place.

If the safety seat is not anchored properly, the risk of a child

being injured in a crash greatly increases.

2003 Explorer (exp)

Owners Guide (post-2002-fmt)

USA English (fus)

Seating and Safety Restraints

136

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 279 280

Pas de commentaire

Ford 2003 Explorer v.5 Manuel d'utilisateur Page 136