Ford 2003 Expedition v.3 Manuel d'utilisateur télécharger pdf (Page 260)

Removing the spare tire

1. Fold the rear seat down. Refer to

Rear seats in the Seating and

safety restraints chapter.

2. Remove the jack handle and

winch extension from the tray and

assemble them.

3. Open the spare tire winch access

plug in the bottom of the

compartment located behind the 3rd

row seat, very close to the jack and

tools tray.

4. Insert the winch extension tool

assembly through the access hole in

the floor and engage the winch.

5. To remove the spare tire, turn the handle counterclockwise until the

tire is lowered to the ground and the cable is slightly slack.

6. Slide the retainer through the center of the spare tire wheel.

Tire change procedure

To prevent the vehicle from moving when you change a tire, be

sure the parking brake is set, then block (in both directions) the

wheel that is diagonally opposite (other side and end of the vehicle) to

the tire being changed.

If the vehicle slips off the jack, you or someone else could be

seriously injured.

On vehicles equipped with Air Suspension, turn OFF the Air

Suspension switch prior to jacking, hoisting or towing your

vehicle.

Refer to the instruction sheet (located in the rear floor compartment

behind the 3rd row seat with the jack tray tools assembly kit) for

detailed tire change instructions.

Roadside Emergencies

260

1 2 ... 255 256 257 258 259 260 261 262 263 264 265 ... 343 344

Pas de commentaire

Ford 2003 Expedition v.3 Manuel d'utilisateur Page 260