Ford 2002 Escape v.2 Manuel d'utilisateur télécharger pdf (Page 152)

Attaching safety seats with LATCH (Lower Anchors and Tethers for

Children) attachments for child seat anchors

Some child safety seats have two rigid or webbing mounted attachments

that connect to two anchors at certain seating positions in your vehicle.

This type of child seat eliminates the need to use seat belts to attach the

child seat. For forward-facing child seats, the tether strap must also be

attached to the proper tether anchor. See Attaching safety seats with

tether straps in this chapter.

Your vehicle has LATCH anchors for child seat installation at the

following locations:

The anchors on both sides of the

center of the rear seat are provided

primarily for child seats at the

outboard seats, and are further

apart than the pairs of lower

anchors for child seat installation at

other seats. A child seat with rigid

LATCH attachments cannot be

installed at the center rear seat. A

child seat with LATCH attachments on belt webbing can be used at the

center rear seat unless a child seat at an outboard rear seat is attached

to one of these lower anchors. Install a child seat onto the lower anchors

at the center rear seat ONLY IF the child restraint manufacturer

recommends that the child seat can be installed to anchors that are

spaced up to 500 mm (19 in) apart.

Never attach two LATCH child safety seats to the same anchor.

In a crash, one anchor may not be strong enough to hold two

child safety seat attachments and may break, causing serious injury or

death.

Seating and Safety Restraints

152

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 279 280

Pas de commentaire

Ford 2002 Escape v.2 Manuel d'utilisateur Page 152