Ford 2002 Escape v.2 Manuel d'utilisateur télécharger pdf (Page 257)

When changing the air filter element, use only the Motorcraft air filter

element listed. Refer to Motorcraft Part Numbers.

Note: Do not start your engine with the air cleaner removed and do not

remove it while the engine is running.

Changing the air filter element

1. Loosen the clamp that secures the air inlet tube to the engine air filter

cover and disconnect the tube from the cover.

2. Release the clamps that secure the air filter housing cover.

3. Carefully separate the two halves

of the air filter housing.

4. Remove the air filter element from the air filter housing.

5. Wipe the air filter housing and cover clean to remove any dirt or

debris and to ensure good sealing.

6. Install a new air filter element. Be

careful not to crimp the filter

element edges between the air filter

housing and cover. This could cause

filter damage and allow unfiltered

air to enter the engine if not

properly seated.

7. Replace the air filter housing cover and secure the clamps.

8. Replace the air inlet tube and secure the clamp.

Note: Failure to use the correct air filter element may result in severe

engine damage. The customer warranty may be voided for any damage to

the engine if the correct air filter element is not used.

Maintenance and Specifications

257

1 2 ... 252 253 254 255 256 257 258 259 260 261 262 ... 279 280

Pas de commentaire

Ford 2002 Escape v.2 Manuel d'utilisateur Page 257