Ford 2002 Escape v.2 Manuel d'utilisateur télécharger pdf (Page 134)

Do not sit on top of a buckled safety belt to avoid the Belt

Minder chime. Sitting on the safety belt will increase the risk of

injury in an accident. To disable (one-time) or deactivate the Belt

Minder feature please follow the directions stated below.

One time disable

Any time the safety belt is buckled and then unbuckled during an

ignition ON cycle, BeltMinder will be disabled for that ignition cycle only.

Deactivating/activating the BeltMinder feature

Read steps1-9thoroughly before proceeding with the

deactivation/activation programming procedure.

The BeltMinder feature can be deactivated/activated by performing the

following procedure:

Before following the procedure, make sure that:

• the parking brake is set

• the gearshift is in P (Park) (automatic transmission) or the neutral

position (manual transmission).

• the ignition switch is in the OFF position

• all vehicle doors are closed

• the driver’s safety belt is unbuckled

• the parklamps/headlamps are in OFF position (If vehicle is equipped

with Autolamps, this will not affect the procedure.)

To reduce the risk of injury, do not deactivate/activate the Belt

Minder feature while driving the vehicle.

1. Turn the ignition switch to the RUN (or ON) position. (DO NOT

START THE ENGINE)

2. Wait until the safety belt warning light turns off. (Approximately 1–2

minutes)

• Steps 3–5 must be completed within 60 seconds or the procedure will

have to be repeated.

3. Uncoil then retract the safety belt three times, ending with the safety

belt retracted. This can be done before or during BeltMinder warning

activation.

Seating and Safety Restraints

134

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 279 280

Pas de commentaire

Ford 2002 Escape v.2 Manuel d'utilisateur Page 134